Rigol DL3000 User Manual

RIGOL Chapter 2 Front Panel Operations
2-110 DL3000 User’s Guide
 The filename suffix must be ".lic".
 Contents requirement:
Line 1: product serial number (Press Utility  System to obtain the
product serial number);
Line 2: option license code;
Line 3: empty line (cannot be omitted)
Note: The hyphens in the option license should be omitted.
Option Installation Procedures:
 Edit the option installation file that meets the above requirements and
save it to the USB storage device.
 Power on the instrument and insert the USB storage device. Press
Store on the front panel of the load to enter the storage and recall
interface.
 In the storage and recall interface, refer to "Store and Recall" to
complete reading the option installation file according to the following
step.
Select "D:"  select the specified file  press Read.
Method 3: Send SCPI Commands
To open remote control window and send the option installation
command :LIC:SET <license>, refer to "Remote Control".
Wherein, <license> is the option license code, and the hyphens in the code
should be omitted.
For example, :LIC:SET UVF2L3N3XXKYTB73PPRSA4XDMSRT
If the option has been successfully installed, a prompt message will be displayed;
otherwise, a message indicating a failed installation will be displayed.
Filename Suffix
Empty Line
Product Serial Number
Option License

Rigol DL3000 Specifications

General

Brand	Rigol
Model	DL3000
Category	Measuring Instruments
Language	English