Chapter 2 Front Panel Operations RIGOL
DL3000 User’s Guide 2-49
the descriptions in "Parameter Setting Method".
Set C_Step
(1) In the main interface, press C_Step to switch the parameter focus to
"C_Step".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For the
setting methods, refer to the descriptions of the built-in help information or
refer to the descriptions in "Parameter Setting Method".
Set Delay_Step
(1) In the main interface, press Delay_Step to switch the parameter focus to
"Delay_Step".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For the
setting methods, refer to the descriptions of the built-in help information or
refer to the descriptions in "Parameter Setting Method".
Set OCP_V
(1) In the main interface, press OCP_V to switch the parameter focus to
"OCP_V".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For the
setting methods, refer to the descriptions of the built-in help information or
refer to the descriptions in "Parameter Setting Method".
Set C_Max
(1) In the main interface, press C_Max to switch the parameter focus to
"C_Max".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For the
setting methods, refer to the descriptions of the built-in help information or
refer to the descriptions in "Parameter Setting Method".
Set C_Min
(1) In the main interface, press C_Min to switch the parameter focus to
"C_Min".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For
setting methods, refer to the descriptions of the help information or refer to
the descriptions in "Parameter Setting Method".
Set T_Limit
(1) In the main interface, press T_Limit to switch the parameter focus to
"T_Limit".
(2) Enter a value by using the numeric keys, arrow keys, or the knob. For
setting methods, refer to the descriptions of the help information or refer to
the descriptions in "Parameter Setting Method".
To Next Page
Loading...
Need help?
General
