1. AUTO
Command Format:
AUTO
AUTO?
Function:
The command sets or queries the mode of Auto range of the instrument.
Explanation:
AUTO: Set the mode of range of the instrument as Auto. If this mode can not be
selected ( or when Diode or Continuity test is active ), execution error will be
occur.
AUTO?: Query whether the instrument is in Auto range mode or not.
Return Format:
The query returns the current mode of range. 1 denotes Auto, 2 denotes Not.
2. FIXED
Command Format:
FIXED
Function:
The command exits the Auto range mode of main display and enters into Manual
mode. The current range is to be the selected range.
3. RANGE
Command Format:
RANGE□<value range>
RANGE1?
RANGE2?
Function:
RANGE□<value range>: Set the range of main display as <value range>. These
range are related to the range of Function (Current, Voltage, Resistance, and
To Next Page
Loading...
