5. :measure:voltage:DC:range?
Command Format
:measure:voltage:DC:range?
Function:
The command queries the measuring range of DC voltage.
Explanation:
Please make sure the DCV function must has been set at least one time before
using this command.
Return Format:
The query returns the parameter related to current range : 0, 1, 2, 3 or 4 (see
Table 3-1).
6. :measure:voltage:DC:impedance
Command Format:
:measure:voltage:DC:impedance?
:measure:voltage:DC:impedance□{10M|10G}
Function:
The command queries and sets DC voltage impedance.
Explanations:
:measure:voltage:DC:impedance?: Return 10M or 10G (>10 G).
:measure:voltage:DC:impedance□{10M|10G}: Set the DC voltage impedance as
10 MΩ or >10 GΩ.
Remarks: ―>10G‖ is available only when the range of DC is in 200 mV or 2 V.
Example：
To set the DC voltage impedance as 10 GΩ：
:measure:voltage:DC:impedance□10G
7. :measure:voltage:DC:filter:state
To Next Page
Loading...
