Rigol DS1000 Series Programming Guide

RIGOL
© 2008 RIGOL Technologies, Inc.
Programming Guide for DS1000/DS1000CA Series
1-2
Communication Ports
Computers communicate with the oscilloscope by sending and receiving messages
over an I/O port, such as USB, GPIB port or a RS-232 port. Commands appear as
ASCII character strings embedded inside the output statements of a “host” language
available on your computer. The input commands of the host language are used to
read responses from the oscilloscope.
Basic operations that you can do with a computer and an oscilloscope include:
 Set up the oscilloscope.
 Make measurements.
 Retrieve data (waveforms or measurements) from the oscilloscope.

Rigol DS1000 Series Specifications

General

Brand	Rigol
Model	DS1000 Series
Category	Test Equipment
Language	English