Rigol DS1000CA Series - Page 106

RIGOL
2-80 Copyright ©1998-2008 RIGOL Technologies, Inc.
User’s Guide for DS1000CA Series
Service
Press Utility→Service to go to the following menu.
Figure 2-100
Table 2-67 The Service menu
Menu Settings
System Info Press to display system information.
Screen Test Press to run screen test program.
Color Test Press to run color test.
Key Test Press to run keypad test program.
1. System Info:
Press this soft button to display the information of the oscilloscope. Product Model,
Serial No., Software version and Installed module of the oscilloscope. Follow the
prompting message “<<Press ‘RUN’ Key to Exit the Test>>" to exit this interface.
2. Screen Test:
Press this soft button to run Screen Test program. The screen turns red, green and
blue in sequence. Keep pressing the RUN/STOP button to check the screen display
failures.
3. Color Test:
Select Color Test to enter the color test screen, the hue, saturation, brightness, or
red, green and blue components can be adjusted by turning the (
) knob, confirm
selection by pushing the
( ) knob.