Rigol DS1000Z-E Series User Manual

RIGOL Chapter 5 To Trigger the Oscilloscope
5-20 DS1000Z-E User Guide
ns to 10 s.
Trigger Mode:
Press Sweep to open the trigger mode list and select auto, normal or single. For the
details, please refer to "Trigger Mode". The corresponding status light of the
current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameter (noise rejection) under this trigger type.
Trigger Level:
When the trigger source is an analog channel, you can use TRIGGER LEVEL to
modify the level. For the details, please refer to the introduction of "Trigger Level".

Rigol DS1000Z-E Series Specifications

General

Brand	Rigol
Model	DS1000Z-E Series
Category	Measuring Instruments
Language	English