Rigol DSG800 Series User Manual

RIGOL Chapter 2 Front Panel Operations
2-40 DSG800 User's Guide
Figure 2-3 LAN Parameter Setup
 Reset
Turn DHCP and auto IP on and turn manual IP off; clear the network
password set and restore it to the factory setting.
 Apply
After configuring the LAN parameters, press Apply  OK and the
configuration takes effect.
 DHCP
One of the IP address setting methods. When DHCP it turned on, the DHCP
server will assign network parameters (such as the IP address, subnet mask
and gateway) for the RF signal generator according to the current network
configuration.
 Auto-IP
One of the IP address setting methods. When auto IP is turned on, the RF
signal generator will acquire an IP address from 169.254.0.1 to
169.254.255.254 and subnet mask 255.255.0.0 automatically according to
the current network configuration.
 Manual-IP
One of the IP address setting methods. When manual IP is turned on, users
can define the IP address of the RF signal generator.
 IP
Set the IP address, subnet mask and gateway manually.
a) Press IP Address and use the numeric keyboard to input the desired
IP address.
The format of the IP address is nnn.nnn.nnn.nnn. Wherein, the first
nnn ranges from 1 to 223 (except 127) and the other three range from
w ww. . com
information@itm.com1.800.561.8187

Rigol DSG800 Series Specifications

General

Brand	Rigol
Model	DSG800 Series
Category	Portable Generator
Language	English