Rigol DSG821 - Page 60

RIGOL Chapter 2 Front Panel Operations
2-28 DSG800 User Guide
The format of the train list file loaded is as shown in the table below. Note that
when you edit the value in the train list, if no unit is added, then the default time
unit is us.
SN
[1]
OnTime
[2]
OffTime
[3]
Repeat
[4]
DwellTime
[5]
1
4.00 ms
5.00 ms
2
18.00 ms
2
2.00 ms
4.00 ms
5
30.00 ms
3
15.55 ms
100.5 us
2
31.30 ms
Note
[1]
: The number of the pulse set.
Note
[2]
: The duration of the high level corresponding to the pulse set.
Note
[3]
: The duration of the low level corresponding to the pulse set.
Note
[4]
: The number of repetitions of the pulse set.
Note
[5]
: The duration of the pulse currently set.
The pulse train (the number of repetitions of pulse 1 is 2) loaded is as shown in
the figure below.
OnTime
OffTime
… …
DwellTime
Repeat: 1
Repeat: 2
 View the list
You can press View to view the information of the train list currently loaded.
Pressing any key (except the arrow keys and knob) at the front panel will return
to the train list menu.
Note: This menu is only valid after a train list file is loaded.
Tip: To load or view the train list, you need to install the option DSG800-PUG. For the
installation methods, refer to "License".
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30