RIKA Topo - Operation and Shutdown; Easy 40 Operation; Stopping and Burnout

© EUROHEAT DISTRIBUTORS (H.B.S) LTD. June 2011
Instructions Part Number IN1227 Ed 1
16
If switching off occurs again 50 sec. within switching
on ( key) (at least 2 sec. key), the pellet
stove returns to inactive status.
If switching off occurs during the ignition process
(IGNIT or START) (at least 2 sec. key), IGNIT OFF
or START OFF appears in the display and the burn-out
phase is initiated (duration approx. 10 min).
Easy 40 – Operation
Key Display Description
EASY
40
Standard display for stove
switched on in simple
heating mode. (40 is the
output in %)
EASY
45
Pressing increases
output by 5%
EASY
40
Pressing decreases
output by 5%
+
+
Easy 40 – Switch Off
Key Display Description
STOP
EASY
OFF
The burnout phase is
initiated by pressing
for at least 2 seconds (until
the change is visible on the
display).
The appliance shuts down
after completing the
burnout phase and returns
to its inactive state.
Stopping During Ignition or Start Phase
Cleaning and Tipping During Operation
The automatic cleaning process is conducted every hour
for approx. 2 minutes. During this phase the air vents
that are necessary for combustion are blown clean.
The pellet stove enters the burnout phase every 6
hours. A tipping process is conducted automatically.
The start-up phase is automatically re-initiated after
completion of the burnout phase and operation
continues.
+
I G N I T
E A S Y
5 0
S T A R T
E A S Y
O F F
Change heat output by
pressing the + or – key
(change in 5 % increments)
Pressing the button
(until the change is
visible on the display)