How to fix Riken Keiki Gas Detectors when the power cannot be turned on?
If the power on your Riken Keiki Gas Detector won't turn on, check the following: * Ensure the batteries aren't depleted by replacing them in a safe area. * Verify the batteries are inserted with the correct polarity. * Press and hold the POWER/MODE button for at least three seconds until you hear a blip. * Make sure the battery cover is completely closed.
What to do if my Riken Keiki Gas Detectors show a low battery voltage alarm [FAIL BATTERY]?
If your Riken Keiki Gas Detector displays [FAIL BATTERY], it means the battery levels are low. Turn off the power and replace the batteries in a safe environment.
Why won't the alarm stop on my Riken Keiki Gas Detectors even when the gas is gone?
If your Riken Keiki Gas Detector alarm continues even after gas concentrations are below the alarm setpoint, it's likely because the alarm is self-latching. For OX-04G, OX-04, HS-04, SC-04 (SO2, NO2, HCN) models, press the POWER/MODE button after the alarm occurs. For CO-04, CO-04 (C-), CX-04 models with a self-latching gas alarm pattern, press the POWER/MODE button after the alarm occurs.
What to do if air calibration is not possible on Riken Keiki Gas Detectors and [FAIL AIR] appears?
If your Riken Keiki Gas Detector displays [FAIL AIR], it indicates that fresh air isn't being supplied to the product. Make sure the surrounding air is fresh. If the issue persists, it may indicate that the sensor sensitivity has degraded, and you should contact Riken Keiki to request sensor replacement.
What does [FAIL CLOCK] mean on my Riken Keiki Gas Detectors?
If your Riken Keiki Gas Detector shows [FAIL CLOCK], set the date and time. If the issue happens often, the internal clock may be faulty, and you should contact Riken Keiki to request internal clock replacement.
What does [FAIL SENSOR] mean on Riken Keiki Gas Detectors?
If your Riken Keiki Gas Detectors display [FAIL SENSOR], it means the sensor sensitivity has degraded, and you should contact Riken Keiki to request sensor replacement.
What does system abnormality [FAIL SYSTEM] mean for Riken Keiki Gas Detectors?
If your Riken Keiki Gas Detector displays [FAIL SYSTEM], it indicates a circuit abnormality within the main unit. Contact Riken Keiki for repair.
General| Brand | Riken Keiki |
|---|---|
| Model | 04 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
