CAUTION!
You’ll be working with electrical wires during
the install process. If you are uncomfortable
or inexperienced with doing so, consult with
a licensed electrician. Do not wire your Ring
Doorbell to a DC-powered intercom system
or other DC power source.
12 13
If replacing an existing doorbell, shut o
power at the breaker. Then remove the
doorbell button from the wall and
disconnect the wires. If you’re not sure
which breaker controls your doorbell,
turn o the master breaker for your home,
or contact an electrician.
Your Ring Doorbell is compatible with
doorbell systems supplying 8–24 volts AC
at 50 or 60Hz, 40VA max.
Optional: Remove your existing doorbell
The Corner Mount can angle your Ring
Doorbell to improve motion detection
and provide a better view
Install the anchors.
If installing on stucco, brick, or concrete,
mark 2 drill holes using the Corner Mount as a
template. Then, use a 1/4” masonry drill bit to
drill holes in your wall, and insert the included
anchors.
(If you’re installing on wood, skip this step.)
Optional: Install the Corner Mount
To Next Page
Loading...
Need help?
General
