With power still turned off at the fuse box, slide the earth wire into the centre bay on the bottom of
the terminal block and tighten with the flathead end of the included screwdriver. Then slide the line
wire into the bay on the bottom of the terminal block marked “L” and tighten with the flathead end
of the screwdriver.
Repeat with the neutral wire, sliding it into the bay marked “N” and tightening with the flathead end
of the screwdriver.
Tug each wire individually to make sure they are secure.
10. Replace the pressing plate
Once you’ve confirmed the wires are secure, replace the pressing plate over the power cable and
tighten with the Phillips head end of the screwdriver.
11. Hang it up
Locate the nylon strap on the back of the Floodlight Cam Wired Plus light fixture, and loop the
plastic buckle at the end over the plastic hook on the mounting plate. Make sure the buckle and
hook are secure before releasing the light fixture.
To Next Page
Loading...
