EasyManua.ls Logo

Rinnai Blaze 21 - Rinnai Heater Care and Maintenance Guide; Rinnai Heater Air Filter Maintenance; Rinnai Heater Air Filter Removal and Cleaning; Rinnai Heater Service Recommendations

Rinnai Blaze 21
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CARE AND MAINTENANCE
Your heater needs very little maintenance, but the following information will help you to keep it looking
good and working efficiently.
AIR FILTERS
Dusty filters reduce heating effectiveness.
DO NOT wait for Filter indicator to come on before
cleaning filters.
DO NOT use the heater with the filter warning lamp on. This
may cause it to overheat.
REMOVING FILTERS
SERVICE
Unplug before cleaning.
All parts of the heater can be cleaned using a soft, damp cloth.
DO NOT use solvents to clean any parts.
DO NOT spray aerosols in the vicinity of the heater whilst in operation.
DO NOT place articles on or against this heater.
DO NOT store flammable materials near this heater.
IMPORTANT
8
7
8
7
30
Rinnai recommend that this appliance and installation be inspected and serviced every 2 years.
If the power supply cord or any other component of the heater are damaged, they must be replaced
by Rinnai or a suitably qualified person.
Any service or repair work should only be carried out by an authorised person. For the location of
your nearest service centre call 0800 2 Rinnai.
Filters require cleaning at least once a week during the heating
season to prevent blockages.
For cleaning Filter 1 , undo and remove the retaining screw
(ensure the retaining screw is stored in a safe place).
Carefully lift filters up then backwards to remove from locating
tabs.
With the careful use of a vacuum cleaner, gently remove any
contaminates such as dust and lint being careful not to
damage the filter mesh.
Replace filters by carefully repositioning the location tabs and
fasten in place with the retaining screw.
Filter 2 (the small filter) should be left in position for
cleaning, carefully use a vacuum cleaner to remove any
contaminates such as dust and lint.
Service calls for general cleaning, maintenance and wear and tear are not necessarily
covered under the warranty. Service calls of this nature may be chargeable.
WARNING
NOTE
Do not operate this appliance without filters and in place or if the mesh is
damaged
8
7
8
7
Rinnai Operation Manual16

Related product manuals