IMPORTANT POINTS
Unpack heater:
Check for damage. If heater is damaged, contact your supplier for advice. Before
installing the heater, check it is labelled for the correct gas type. Refer to local
gas authority for confirmation of gas type if you are in doubt.
Included in Carton:
Customers Operating Information
IMPORTANT
1.
2.
3.
4.
5.
6.
7.
8.
The appliance must be installed in accordance with the local gas authority
regulations.
For information on gas rate, see data plate on the appliance.
When using this appliance, ensure that the room is correctly ventilated.
Check NZS 5261 or the local gas authority for information on ventilation
requirements.
DO NOT install in bedroom or bathroom.
This heater must not be installed’where curtains or other combustible materials
could come into contact with it. In some cases curtains may need restraining.
It must also be 50mm clear of walls.
This appliance is not designed to be built in.
If you move house, check the gas type in the area where you are moving to.
The local gas authority will be able to advise on local regulations.
This heater discharges a large volume of warm air at low level to provide
even heat distribution. If the air in the room contains cooking vapour or
cigarette smoke, and the heater is used on a carpet, the surface of the carpet
may become discoloured.
In addition, some nylon carpets contain dyes which may be affected by the
warm air flow.
Some soft vinyl surfaces are also subject to discolouration by warm air.
To prevent discolouration of carpets etc., a mat should be placed under the
appliance, extending about 750mm in front of it.
Diagram 1 shows clearances required
around this heater whilst in operation.
50mm
750mm
-2-
To Next Page
Loading...
Need help?
General
