L
TEMPERATURE TEMPERATURE CONTROL CONTROL
The thermostat automatically
modulates the burner and the fan to
maintain the room temperature which
you have selected.
To change the room temperature, simply
adjust the temperature control buttons
until the desired setting is indicated.
The heater will run on high for 1 to 2
minutes after ignition no matter where
the temperature control is set.
The temperature range from LO to HI
is about 12°C to 36°C. Temperature
control may be affected by the
positioning of the heater.
Temperature Control
l-0 1 1 m 8 1 1 8 1”’
v
DOWN UP
CONTROL BUTTONS
ROOM ROOM TEMPERATURE TEMPERATURE
IjISPLAY IjISPLAY
Temperature is indicated by the L.E.D.
display on the control panel. The room
temperature is indicated by the flashing
L.E.D., and the set temperature by the
steady L.E.D. When the set temperature
is reached,
the flashing L.E.D.
disappears and the temperature is
indicated by the steady L.E.D. You will
notice the, fan speed changing as the
heater modulates to match the room
temperature.
Temperature Level
0 o$go 0 8 0
0
/ 1
ROOM’ TEMP
(Flashing)
SET TEMP
(Steady)
TO TURN UNIT OFF
Depress ignition button again.
The switch will return to the off
position.
Disconnect hose after use.
Do not turn off by unplugging at the
power point. Convection fan continues
to run until heater is cool.
The convection fan may start again
after a few minutes to remove any
residual heat. ’
Ignition Button
PUSH
ON OFF
a 1
-7-
To Next Page
Loading...
Need help?
General
