8 | Evolve 950 Operation Guide: 12472-A
Clearances (from the edge of the glass)
The appliance must not be installed where curtains or other combustible
materials could come into contact with the heater. In some case curtains may
need restraining. The clearances listed below are minimum clearances unless
otherwise stated.
Floor protection
Heat emanating from this
fire may over time affect
the appearance of some
materials used for flooring,
such as, carpet, vinyl, cork or
timber. This may be amplified
if the air contains cooking
vapours or cigarette smoke.
To avoid this occurring, it is
recommended that a mat
be placed in front of this
appliance.
Mantels and surrounds
A mantel and surround are
allowed providing they
are outside the minimum
clearances shown.
Hearths
A hearth is not necessary but
can be used for decorative
purposes or protection of
sensitive flooring if required.
A hearth must not obscure
the front of the fire.
400
400
1000
1000
To ceiling
400
Note: Measurements are taken from the edge of the glass.
The 400 mm side clearance includes side walls.
C - Surround from side of glass
B - Mantel depth
A - Mantel height from top of glass
D - Surround
projection
A Mantel height from top of glass 400 mm min.
B Mantel depth at A - 400 mm (vertical clearance) 250 mm max.
For every 50 mm of added mantel depth, there must be an additional 100 mm of
vertical clearance. For example; a mantel depth (B) of 350 mm will require 600
mm (A) of vertical clearance.
C Surround from side of glass 250 mm min.
D Surround projection at C - 250 mm (side clearance) 250 mm max.
To Next Page
Loading...
Need help?
General
