Rinnai FC824 User Manual

Fan Convector Manual 5
Prepareforinstallaon
Parts included
Tools needed
Materials needed
Gas Fan Convecon Heater
Anchors
Screws
Manual Gas Shut Off Valve
Floor Fixing Plate
Pipe wrenches (2)
Adjustable pliers
Screwdrivers (2)
Wire cuers
Gloves
Safety glasses
Level
Tools that might be needed
Saw
Threading machine with
heads and oiler
Steel pipe cuer
Manometer
Soap soluon or other
appropriate leak
detector soluon.
Approved pipe thread
pipe sealant for either
natural gas or propane.
GeneralInstrucons(connued)
 A licensed professional should install the
appliance and inspect it before use.
 When unpacking the appliance, check for the
correct gas type and for damage. The Operaon
and Installaon Manual and a manual gas valve
are included.
 This appliance is intended for supplemental
heang only. The Internaonal Fuel Gas Code
Standard 620‐6 “Prohibited Use” states that “One
or more unvented room heaters shall not be used
as a sole source of comfort heang in any
dwelling”.
 Donotinstall this appliance in a bedroom or
bathroom.
 Donotinstall this appliance in a windy area such
as facing a window or near a door leading to the
outside.
 DoNotinstall this appliance above 5,200.
 If you move, check the gas type in your new area.
The local gas authority will be able to advise on
local regulaons.
 If the flooring is carpet, le, or other combusble
material other than wood, then the appliance
must be installed on a metal or wood panel
extending the full width and depth of the
appliance.
 This appliance discharges a large volume of warm
air next to the floor. Any parcles in the air such
as cigaree smoke, lint, dust, or debris could
cause discoloraon in nylon carpets containing
dyes or vinyl surfaces.
 This appliance is not designed to be built into or
mounted directly in a wall
 Rinnai suggests that a dedicated electrical circuit
with a 120VAC, 60 Hz, 10 amp power source be
used.
 A 1/8” test plug is provided for tesng of
manifold differenal pressure. It is located on the
modulang gas valve.
 The flow of combuson and venlaon air must
not be obstructed.
 Note that in some regions, an unvented gas
heater will increase the amount of humidity in the
room.

Rinnai FC824 Specifications

General

Brand	Rinnai
Model	FC824
Category	Heater
Language	English