12
Temperatures above 50°C should not be selectable from remote controls installed in environments
such as bathrooms or the like: this is to reduce the risk of burns. Contact your installer to correct
the problem.
Prior to use, to avoid burns, it is recommended to always check the hot water temperature. In
hot water temperature.
During hot water delivery the set temperature can always be lowered (up to a minimum of 37°C).
For safety reasons, it is not possible to increase its value above 43°C: this is only possible when
the withdrawal of water is stopped (all the taps are closed).
until the withdrawal has been completely stopped.
To delete the ‘beep’ emitted by the keys on the control panel, press the
and buttons at the
same time for at least three seconds. Repeat the procedure to cancel the choice made.
Transferring priority
When more than one command is installed, to change the temperature of
the hot water supplied, it is necessary to transfer the ‘priority’ function to the
desired command. The transfer of the function is not possible when the ‘In
Use’ led is on: this means that the appliance is already heating the water
and that some users are active.
The led of the ‘Priority’ key lights up when this function is active on the
function.
Lock function
To prevent tampering and increase the safety level of the product, especially
for children, it is possible to lock the control panel.
seconds, the ‘Priority’ keys and the key to increase the temperature (up
of blocking commands.
When the panel is locked, the display shows ‘LOC’ (Fig.2) alternating with
the selected temperature on the display. All connected commands will be
Operation with multiple Controllers
The installation of accessories remote commands, allows the temperature
supplied to all the users at the temperature set on the control which has the
‘priority function’ activated.
Standard remote controls (such as the one supplied with outdoor models:
MC-601) and/or Deluxe remote controls can be connected to the device.
Available Deluxe models are: the ‘kitchen’ model MC-100V and the
‘bathroom’ model BC-100V.
Standard models allow temperature selection and self-diagnosis functions.
The Deluxe remote controls, in addition to the functions of the Standard
models, have an alert voice speaker, a clock function and, the Deluxe
(contact Rinnai for further information on the commands remote Deluxe or
visit the Rinnai website: www.rinnaiuk.com).
Remote controls of another brand are not compatible.
Fig. 1
Fig. 2
NOTE
CAUTION
Deluxe ‘kitchen’ optional remote
controller - MC-100V
Deluxe ‘bathroom’ optional remote
controller - BC-100V
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
