18
Installation Warnings
The following section contains technical information regarding the installation of the product. For what concerns
issues related to the installation (safety, environmental protection, accident prevention, etc.) it is necessary to
respect the dictates of the current legislation and the principles of good technique. Under the current law, the
APPLIANCE LOCATION
The outdoor models are designed for outdoor installation only: they must be installed in a raised position in the open
air with natural ventilation, without standing areas; where the losses of gas and combustion products are rapidly
dispersed by wind or by natural convection.
The OUTDOOR models can be installed outdoors without protection from rain, snow, etc. The
minimum ambient temperature allowed for normal operation is -20°C.
The INDOOR models can be installed in outdoor environments, partially protected: not exposed to
direct action of atmospheric precipitation. The minimum environmental temperature allowed for
normal operation is -15°C.
All pipes must be insulated with appropriate insulating materials to prevent freezing.
distances from the architectural elements.
The water heater must be positioned minimizing the distance of the utilities that use it most frequently to reduce the
wait for hot water from the appliance to the points of use.
It is necessary to provide an electrical plug with AC230V/50Hz and grounding power supply near the appliance,
it is necessary to provide a protected and waterproof outlet. The electrical cable of the appliance is 1.5m long.
This product can not be used for direct heating of swimming pool water.
Provide an adequate system for collecting and disposing of liquids in the lower part of the appliance to prevent damage
to property in the event of accidental breakage of pipes.
of any element that may cause corrosion of the components (this includes corrosive substances, for example, in
aerosols, sprays, detergents, chemical solvents, oil-based paints, refrigerants, etc.). The appliance and its exhaust
and ventilation apparatus must not be installed in environments where corrosive, combustible or chemical substances
are present. Damage and repairs due to corrosive compounds in the air are not covered by warranty.
Installations in coastal areas may require more frequent maintenance due to corrosive phenomena of the sea air.
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
