Risco AGM - CLIP Control; Follow Me Report; Follow Me Events

12 AGM - Installation and Programming Instructions
8.2 CLIP Control
Output 1 can be defined as CLIP control type. The CLIP (Calling Line Identity
Presentation) feature enables the user to activate output 1 from Follow Me numbers
authorized with this function, without being charged for a call from this phone to the
AGM.
To be able to perform this operation, the user has to initiate a call to the AGM and hang
up after 4 to 5 rings.
While waiting, the AGM recognizes the telephone number (using the caller ID feature of
the GSM network) that the call is initiated from, and activates output 1.
9. Follow Me Report
The AGM allows reporting events to eight Follow Me destinations using one of the
following three reporting types:
Ê Voice messaging: Using the optional Plug on voice module (RP200GSV00A)
the AGM enables to assign events with short audible messages. Up to four pre-
recorded messages can be recorded (10 second message each).
Ê SMS: Predefined SMS event messages can be sent to a Follow Me number.
Note:
SMS input event messages can be manually defined according to the installation type.
Ê E-mail: The AGM can E-mail event messages to predefined E-mail addresses
using GPRS. In order to do so, GPRS channel must be activated on the SIM
and the GPRS parameters should be defined (see page 20).
9.1 Follow Me Events
Event Event description SMS Default
Message
Input 1-4 event Report to Follow Me will be established when an input is
triggered
I1:"Intruder alarm"
I2: "Panic alarm"
I3: "Fire alarm"
I4: "Emergency
alarm"
Input 1-4 restore Report to Follow Me will be established when an input is
restored to normal condition
I1:"Intruder restore"
I2: "Panic restore"
I3: "Fire restore"
I4: "Emergency res."
Tamper Report to Follow Me will be established following a
tamper alarm
"GSM box tamper"
Tamper restore Report to Follow Me will be established following to the
restore of tamper alarm
"GSM box tamper OK
No PSTN Report to Follow Me will be established following loss of
PSTN line (connected to the GSM). If PSTN Loss Delay
time period is defined, the message will be sent after the
delay time
"Phone Line Fail"
PSTN Restore Report to Follow Me will be established following to the
restore of PSTN line (connected to the GSM) to normal
condition
"Phone Line OK"
GSM Restored Report to Follow Me will be established following to the
restore of the GSM line to normal condition. The AGM
can establish a connection using the GSM network.
"GSM line OK"