Telephone Connection (Ref.: FCC Part 68)
1. This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the
ACTA. On the bottom panel of this equipment is a label, that contains among other information, a
product identifier in the format US:RISAL10BAGM. If requested, this number must be provided to
the telephone company.
2. This equipment is designed to be connected to the telephone network using a terminal block,
RJ31X or RJ 11. See Installation Instructions for details.
3. A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for
details.
4. The REN is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an
incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be
certain of the number of devices that may be connected to a line, as determined by the total
RENs, contact the local telephone company. The REN of this alarm system is part of the product
identifier that has the format US:RISAL10BAGM.
5. If this equipment US:RISAL10BAGM causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service may be required.
But if advance notice is not practical, the telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a compliant with the FCC if you believe it is
necessary.
6. The telephone company may make changes in its facilities, equipment, operations or procedures
that could affect the operation of the equipment. If this happens the telephone company will
provide advance notice in order for you to make necessary modifications to maintain
uninterrupted service.
7. If trouble is experienced with this equipment US:RISAL10BAGM, for repair or warranty
information please contact RISCO Group USA Inc 2822 NW 79th Ave. Miami, Florida 33122
USA, phone number 305 592 3820, URL: sales@riscogroupusa.com.
If the equipment is causing harm to the telephone network, the telephone company may request
that you disconnect the equipment until the problem is resolved.
8. Connection to party line service is subjected to state tariffs. Contact the state public utility
commission, public service commission or corporation for information.
9. If your home has specially wired alarm equipment connected to the telephone line, ensure the
installation of this equipment US:RISAL10BAGM does not disable your alarm equipment. If you
have questions about what will disable alarm equipment, consult your telephone company or
qualified installer.
!
Caution:
To ensure proper operation, this equipment must be installed according to the enclosed
installation instructions. To verify that the equipment is operating properly and can successfully
report an alarm, this equipment must be tested immediately after installation, and periodically
thereafter, according to the enclosed test.
!
Note:
Equipment must be installed according to the manufacturer instructions in order for the alarm
dialing equipment to work properly when other equipment connected to the same line is in use.
!
Caution:
Verification of the Line Seize capability should be made immediately after installation, and
periodically thereafter, in order to ensure that this equipment can initiate a call even when other
equipment (telephone, answering machine, computer modem, etc.) connected to the same line
in use.
To Next Page
Loading...
