7. Working life
72
233
Activation of the load resistor (only with RKMultiControl quadro):
Switching the load resistor on or off with interconnected controllers.
To ensure faultless communication between multiple controllers in one bus
network, the first and last controller must be defined with a load resistance.
By pressing the UP and DOWN buttons, the following values can be set:
0 = off (load resistor deactivated)
1 = on (load resistor activated)
0
311
Change the position of the decimal point of the height display. By pressing the
UP and DOWN buttons, the decimal point can be shifted to the left or to the
right:
.xxxx
x.xxx
xx.xx
xxx.x
xxxx.
xxxx
xxx.x
To Next Page
Loading...
