7. Working life
77
DeutschEnglishFrancaisEspanolItaliano
7.12.3 Place position on a hot key
Example: You would like to store the position "50 P." on hot key 2.
• Move the drives with the UP or DOWN keys until "50 P." appears in the display.
• Press the F key until "POS.-" appears in the display.
• Press hot key II within 5 seconds.
• You have placed the position on hot key 2.
• You can now drive up to the position with hot key II.
The selected user level and the stored position are still stored, even after switching off the control.
7.12.4 Drive up to stored position
Example: You want to drive up to the stored position 50P. using the hot key.
The position is placed in user level 1 on hot key 2:
• Press the F key until the last selected user level appears in the display (e.g. "USE.2").
• Press hot key I within 5 seconds. "USE.1“appears in the display. You have selected the correct
user level.
• Press hot key II and keep it pressed until the drives have moved into the stored position.
If the correct user level is already set (User level 1 in the example), you can drive up to the desired
position without selecting the user level beforehand.
Ensure that nobody is in the vicinity of the drives when they are moving.
Therefore, only use the hand switch if you can see the drives - danger - risk of
accident!
Ensure that nobody is in the vicinity of the drives when they are moving.
Therefore, only use the hand switch if you can see the drives - danger - risk of
accident!
To Next Page
Loading...
Need help?
General
