-4-
2.2 Each parameter setting
u Method of setting
(2) Press the key to display the input type selection parameter
symbol ( ) on the measured-value (PV) display unit.
At this time, the least significant digit on the set-value (SV)
display unit lights brightly. The digit which lights brightly is
settable.
(3) Press the key to shift the digit which lights brightly up to
the tens digit. The digit which lights brightly shifts as follows
every time the key is pressed.
(4) Press the key to set “ ”. Pressing the key increments
numerals, and pressing the key decrements numerals.
: Thermocouple type L
(5) After finishing the setting, press the key to
register (shifts to next parameter).
Cautions
1. If no key operation is performed for more than 60 sec. during setting or when any
parameter other than
“ ” is displayed, the display returns to “ ”.
2. An example of the REX-C900 is described here, but the same procedure applies to other controllers
(REX-C100, -C400, -C410, and -C700).
To Next Page
Loading...
Need help?
General
