35
Section 4 - In Roof Frame Installation
Preparation
The following is the area space required by a set of in roof panels, please ensure you have this area
available to you before attempting installation of your equipment.
Note: Additional materials and tools necessary and not included in the equipment supplied:
• Minimum of 3 battens in the same size as the ones used in the roof, it can be possible to use
battens from the area under where the collector will be mounted.
• Wood Screws 4 x 80 to x the battens to the roof.
• Battery drill with 2.5mm HSS drill bit, hammer, measuring tape, wood saw, grinder with stone
blade, plumbers tools, ladder, and rope with lashings.
To Next Page
Loading...