Utilities
Just like your house, your Roadtrek has fresh water, electricity, wastewater disposal, heating, and cooling
systems. In the Roadtrek, these systems are self-contained and travel with you.
Your vehicle should be reasonably level to allow normal operation of the system.
Fresh Water
Your freshwater tank uses a gravity fill system, located in the driver's side door pillar. You can fill the freshwater
tanks from a convenient water spigot.
To fill the tanks with fresh water, open the driver's side front door and remove the orange plug in the freshwater fill
port. (Picture 34.1) Fill until water comes out the hole.
City Water
The city water connection is in the rear, underneath the rear bumper on the passenger's side. (Picture 34.2)
Unscrew the white plastic protective cap and connect your clean hose to the water faucet and this connection
point. Turn the faucet on and check for leaks, tightening the connections as necessary.
There is a pressure regulator in the connection. Visit the owner’s section of our website to read the
HOWTO: Potable Water Use guide for instructions on how to hook up to city water.
Picture 34.1
Fresh water tank fill
Picture 34.2
City water connection
To Next Page
Loading...
