Robe ROBIN BMFL LightMaster Side - Page 10

10
6. Attach the FollowSpot Controller (5) to the FollowSpot Controller base (14). During attaching, both spring
locks (10) have to be in an unlocked position (pressed towards the Follow Spot Controller).
7. Connect the FollowSpot Controller base (14) with the xture head (19) by means of the USB cable (17).
This USB connection with xture head is possible for the Robin BMFL FollowSpot only.
If you use the Robin BMFL Spot, Robin BMFL Blade or Robin BMFL WashBeam, connect the FollowSpot
Controller base (14) with the xture base (18) by means of the USB cable (17).
8. Use the balance weight (13) to balance the head in a horizontal position. Always secure the balance weight
in adjusted position by means of the balance locks (9).