22
4. Select desired show le to load it.
After loading, the message " Show Loaded" will appear on the screen: Touch the Cancel button.
5.3 Menu All Lamps On/O
The menu item allows to switch on/o lamp in the Robin BMFL FollowSpot.
5.4 Menu Product IDs
Select this menu item to read a MAC Address , RDM UID, and RDM Label.
5.5 Menu Software Version
Select this item to read the software version of the xture modules:
Display System - a display processor
Module C - a control panel processor
5.6 Menu Settings
System Test - the menu allows you to test jog-wheels and faders.
Ethernet Settings - The menu allows to set the FollowSpot Controller for Ethernet operation.
Ethernet Mode
Artnet - Fixture
receives Artnet protocol
gMAI
- Fixture
receives MANet I protocol
gMA2
- Fixture
receives MANet 2 protocol
sACN
- Fixture
receives sACN protocol
IP Address/Net Mask - Select this menu to set IP address. IP address is the Internet protocol
address.The IP uniquely identies any node (xture) on a network.
There cannot be 2 xtures with the same IP address on the network!
Default IP Address -Preset IP address, you can set up only rst byte of IP address
(2 or 10) e.g. 002.019.052.086.
Custom IP Address - The option enables to set up all bytes of IP address.
Net Mask - The option enables to set up all bytes of Net Mask.
ArtNet Universe - Use
this item to set a Universe (0-255). The Universe is a single DMX
512 frame
of 512 channels.
MANet Settings - Use this menu to set parameters for MANet operation.
MANet Universe I/II - The value of this item can be set in range 1-256.
MANet Session ID - The value of this item can be set in range 1-32.
sACN Settings - Use this menu to set parameters for sACN operation.
sACN Universe - The value of this item can be set in range 1-32000.
sACN Priority - The value of this item can be set in range 0-255.
Controls invert - the menu item allows you to invert faders of the Light Master.
Default settings of faders: fader down-minimum (0 DMX), fader up-maximum (255 DMX).
To Next Page
Loading...
