Robe ROBIN iForte - Page 40

40
Gobo Rotation 1 Error 1 (Gobo Rotation 1 Error 2 )
The messages will appear after the reset of the rotating gobo wheel 1 if the rotating gobos are not located in
the default positions.
Gobo Carousel 2 Error 1 (Gobo Carousel 2 Error 2 )
The messages will appear after the reset of the rotating gobo wheel 2 if this wheel is not located in the default
position.
Gobo Rotation 2 Error 1 (Gobo Rotation 2 Error 2 )
The messages will appear after the reset of the rotating gobo wheel 2 if the rotating gobos are not located in
the default positions.
E󰀨ect Wheel Error 1
The messages will appear after the reset of the e󰀨ect wheel if this wheel is not located in the default position.
Possible reason: missing magnetic sensor or magnet.
E󰀨ect Wheel Error 2
The messages will appear after the reset of the e󰀨ect wheel if this wheel is not located in the default position.
Possible reason: e󰀨ect wheel cannot leave a magnetic sensor.
E󰀨ect Wheel Error 3
The messages will appear after the reset of the e󰀨ect wheel if this wheel is not located in the default position.
Possible reason: error of an alternative reset.
E󰀨ect Wheel Error 4
The messages will appear after the reset of the e󰀨ect wheel if this wheel is not located in the default position
Possible reason: unsuccessful check of the motor track.
Fr. Shutters Rot. Error 1 (Fr. Shutters Rot. Error 2 )
The messages will appear after the reset of the framing shutters module if this module is not located in the
default position.
Fr. Shutter 1 Error 1 (Fr. Shutter 1 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 1 is not located in the
default position.
Fr. Shutter 2 Error 1 (Fr. Shutter 2 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 2 is not located in the
default position.
Fr. Shutter 3 Error 1 (Fr. Shutter 3 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 3 is not located in the
default position.
Fr. Shutter 4 Error 1 (Fr. Shutter 4 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 4 is not located in the
default position.
EEprom Error
Hardware error of the EEprom.
Recharge The battery
The battery on the display board needs to be charged. Let the xture on for cca 6 hrs.
Battery Faulty. Replace it.
The battery on the display board is exhausted and should be replaced immediately.
Pan/Tilt EMS Cal. Error
The EMS system is not calibrated.
Pan/Tilt EMS Error
Control electronics cannot communicate with the EMS system.
Internal Error 1
Communication error between PCBs (error or noise was detected on communication wires)