Robertshaw SENSE SMART 2000 - HEAT;COOL Flashing - No Start; Fan Runs After Cycle Stops; Incorrect Display Format (F;C); Cannot Select Multiple Fan Speeds

44
Symptom Problem Solution
HEAT or COOL is
ashinginthe
LCD.Heangor
cooling has not
started.
Thisisnotafault.Heangor
cooling will start shortly.
The thermostat is performing an
an-cyclemedelaytoconserve
energy and to protect the
heang,coolingorA/Csystem.
Contact the installer if you wish
thisfuncondisabled(NOT
recommended).
The Fan runs on
forsomeme
aertheheang
orcoolingstops,
even when I turn
the thermostat
OFF.
This is not a fault. Fan ON will be
ashing.
Thethermostatisedwitha
FanPurgefunconthatkeeps
the fan running for a minimum
amountofmeaertheheang
or cooling has stopped.
Contact the installer if you want
thisfuncondisabled(NOT
recommended).
Thermostat
displays wrong
format
(F or C).
The thermostat can operate in
both degrees F and degrees C
mode. This is set by your installer.
See page 16 for changing the
CF = XX value.
Cannot select
mulplefan
speeds.
Thermostat set for single fan
speed Sw1 = OFF.
Contact your installer for
informaononchangingyour
display type.