Robin FL-H7500 - Page 41

55
CRANKCASECRANKCASE
66
CYLINDERCYLINDER
CRANKSHAFTCRANKSHAFT
CRANKCASECRANKCASE
Tightening sequence of theTightening sequence of the
SOCKETHEADBOLTS.SOCKETHEADBOLTS.
③③
④④
⑥⑥
⑤⑤
①①
②②⑦⑦
⑧⑧
4040
1)InserttheOILTUBEintothepipeoftheCRANKCASE.1)InserttheOILTUBEintothepipeoftheCRANKCASE.
PartnamePartname
AssemblingInstructionsAssemblingInstructions
1)Applythe4-strokeengineoilovertheinnerwallofthecylinderand1)Applythe4-strokeengineoilovertheinnerwallofthecylinderand
slidingsurfaceofthepiston.slidingsurfaceofthepiston.
2)InserttheCRANKSHAFT(PISTON)intotheCYLINDER.2)InserttheCRANKSHAFT(PISTON)intotheCYLINDER.
3)Applythesiliconsystemliquidgasketequallyovertheshadedareaof3)Applythesiliconsystemliquidgasketequallyovertheshadedareaof
thecrankcaseasshownintheleftfigure(ThreeBond1216recommended).thecrankcaseasshownintheleftfigure(ThreeBond1216recommended).
Becarefulnottofillinthegroovesandholeswiththegasket.Becarefulnottofillinthegroovesandholeswiththegasket.
TheOILSEALshouldnotstickoutTheOILSEALshouldnotstickout
fromtheCRANKCASE.fromtheCRANKCASE.
TightentheBOLTS(TightentheBOLTS(②②andand④④)again.)again.
SOCKETHEADBOLTSOCKETHEADBOLT
M6M6 ×× 30(6PCS)30(6PCS)
Tighteningtorque90Tighteningtorque90 ±± 10kgf･cm10kgf･cm
PipepositionPipeposition