EasyManua.ls Logo

Robin FL-H7500 - Care and Storage; Daily Check and Care; Check and Care after Initial 20-Hour Use; Check and Care after Every 50-Hour Use

Robin FL-H7500
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
VIII. CAREANDSTORAGE
Care described below shows the standard procedure required at the correct engineuseunder
usualconditions.Therefore,itwillnotgiveyouanyguaranteesuchthatcareisnotnecessaryup
totheindicatedtimes.Anaircleanercleaning,forexample,isnecessaryeveryseveral(notten)
hoursadayduringoperationinadust-ladenenvironment.
1) Dailycheckandcare(every10hours)
Checkandcare Reason
1) Partscleaning
2) Testthepartsforbeingnotseated.
Tightenloosescrewsagainifany.
3) Test the fuel pipe for coming away
and/orbend.
4) CheckingandcleaningofthePLUG,
SPARK.
5) Checktheoilquantity.Ifshortsupply
supplementaryoil.
(1) Thedustyaircleanerelementmight cause
poorenginedrive.Also,theoil attachedair
cleanerelementcausesnot onlytheinnerbut
alsoouterparts tobedirtybytheoil.
(2) Thepartsnotseatedcausesvibrationofthe
engineand/oroilleaks.
(3) Thecomingawayand/orbentfuelpipecauses
afuelleakand/orpoorenginestart.
(4) ThebadPLUG,SPARKcausespoorpower
and/orenginestart.
(5) Theenginemightseizeupinoperation with
lackoftheoil.
Apre-operationcheckshouldbedone.
2) Checkandcareafterinitial20-houruse
Checkandcare Reason
1 Oilchange Toremovetheoilthathasinitiallygotdirty.
3) Checkandcareafterevery50-houruse
Checkandcare Reason
1) Oilchange
2) Fuelfiltercleaning
1) Thedirtyoilacceleratesablationoftheparts.
2) Thedirtyfuelfiltercausesthefuelnottobe
suppliedtotheCARBURETORresultingina
poorenginestart.
4) Checkandcareafterevery200-hour
Checkandcare Reason
1) Checkthevalveclearance.Adjustthe
valveclearanceifnecessary.
2) Decreasingintheenginerevolution
needsthecleaningoftheCYLINDER
HEADafterremovingit.
3) Fuelpipereplacement
(1) Increasingintheamountofclearancecauses
thedescentoftheenginepoweroutput,
resultingintheenginemalfunction.
(2) Thedescentoftheenginepoweroutputresults
intheenginemalfunction.
(3) Afuelleakisdangerous.
5) Longtermnonuseofengine
1) Performprocedure1)and2).
2) DrainthefuelfromtheTANK,FUELandCARBURETOR.
3) To prevent rust of the inside of the CYLINDER, pour oil of about 2cc from the
CARBURETORattachingscrewhole,pulltheRECOILSTARTERstartingknobslowly2to3
times,andscrewthePLUG,SPARK.
4) Pull the RECOIL STARTER starting knob slowly and stop pulling at the first heavy
movement(justbeforethepressuretopdeadcenter).
5) Covertheequipmentandstoreitinanuprightpositioninadustlessplace.

Related product manuals