Robur Next-R - Iintroduction; Recipients; Control Device; Symbols and Definitions

Introduction
4
I
I INTRODUCTION
Installation, use and maintenance manual
This Manual is an integral part of the Next-R unit
and must be handed to the end user together with
the appliance.
I.1 RECIPIENTS
This Manual is intended for:
▶ End user, for appropriate and safe use of the appliance.
▶ Qualied installer, for correct appliance installation.
▶ Planner, for specic information on the appliance.
I.2 CONTROL DEVICE
In order to work, the Next-R unit requires a control de-
vice to be connected by the installer (see Paragraph
1.6 p.22 ).
II SYMBOLS AND DEFINITIONS
II.1 KEY TO SYMBOLS
DANGER
WARNING
NOTE
PROCEDURE
REFERENCE (to other document)
II.2 TERMS AND DEFINITIONS
Appliance / Unit = equivalent terms, both used to refer to
the gas unit heater.
TAC = Technical Assistance Centre authorised by Robur.
External request = generic control device (e.g.
thermostat, timer or any other system) equipped with a
voltage-free NO contact and used as control to start/stop
the unit.
OCDS012 1-key basic control = control device that sig-
nals the ame lock-out and allows its resetting.
OCTR000 2-key basic control = control device that sig-
nals the ame lock-out and allows its resetting and also
allows selecting winter operation (space heating) or sum-
mer operation (ventilation).
OTRG005 thermoregulator = control device that allows
to manage settings and operation of one Next-R gas unit
heater.
OCDS008 digital chronothermostat = device that in-
tegrates the functions of room temperature control and
remote control of one or more Next-R gas unit heaters,
when connected to the OTRG005 thermoregulator.
OSWR000 Genius software for remote management =
software that allows, through the OTRG005 termoregula-
tors, to centralize the management of up to 100 Next-R
gas unit heaters.
First start-up = appliance commissioning operation
which may only and exclusively be carried out by a TAC.
III WARNINGS
III.1 GENERAL AND SAFETY WARNINGS
Installer's qualications
Installation must exclusively be performed by a
qualied rm and by skilled personnel, with spe-
cic knowledge on heating, electrical systems and
gas appliances, in compliance with the laws in
force in the Country of installation.
Declaration of conformity
Upon completing installation, the installing rm
shall issue to the owner/client the appliance's
workmanlike conformity declaration, according to
national/local regulations in force and the manu-
facturer's instructions/provisions.
Misuse
The appliance must only be used for the purpos-
es for which it has been designed. Any other use is
deemed hazardous. Incorrect use may aect oper-
ation, duration and safety of the appliance. Adhere
to the manufacturer's instructions.
Use of the appliance by children
The device can be used by children over 8 years
old, and by people with reduced physical, senso-
ry or mental capabilities, or lack of experience or
knowledge, only if they are under surveillance or
after they have received instructions regarding
safe use of the appliance and understanding the
dangers inherent in it. Children should not play
with the appliance.