Roche Accu-Chek Active User Manual

20
Testing blood glucose
4
Applying blood
With test strip outside the meter
2 3
When the test strip and the
flashing blood drop symbols are
displayed:
Remove the test strip from the
meter.
The test strip and blood drop
symbols flash afterwards on the
display. Now you have approx.
20 seconds to apply blood to the
test strip and to slide it into the
meter again. During the last 5
seconds, a beep sounds once per
second. It is to remind you to
slide the test strip with blood
back into the meter. If you do not
slide the test strip back into the
meter within this time, the meter
displays the error message
.
Apply the blood drop to the
centre of the green field.
Lance the side of a fingertip with
your lancing device.
Figure
A
shows the
recommended sites for obtaining
blood.
Encourage a blood drop to form
by gently massaging the finger
towards the fingertip (see
B
).
1
A
B
man_06658768001_02_EN.indb 20 14.08.2013 10:17:59

Roche Accu-Chek Active Specifications

General

Brand	Roche
Model	Accu-Chek Active
Category	Blood Glucose Meter
Language	English