Testing a Blood Sample
83
Powering on the meter
If the function Operator ID is inactive:
1 Place the meter on a level, vibration-free
surface, or hold it in your hand so it is
roughly horizontal.
2 Power the meter on by pressing the
button for approximately 1 second.
You can also power on the meter directly by
inserting a test strip or connecting the power
adapter.
The next steps depend on whether you work
with the function Operator ID set to inactive or
active (see Data handling on page 115).
3 Wait until the Main Menu is displayed.
Main Menu 09:15 am
04/19/2012
Control Test
Review Results
Setup
Patient Test
To Next Page
Loading...
