MagNA Pure 96 System, Customer Training Guide V1.0
22
Preparing the MagNA Pure System
A
A
Waste containers
To drain the external waste container
Reinstall the waste tube in the connector of the empty waste container. To do this properly, push down
the release knob and then insert the waste tube. When you hear a click the tube is fixed.
Ensure that the sensor and the outside of the container are dry.
Ensure that the waste tube is properly connected to the waste container.
Place the waste container back in its compartment.
Ensure that the tube of the waste container is not bent.
Close the load flap.
Fold back the securing clip of the waste tube fastener.
Remove the sensor and the waste tube from the external waste container.
To Next Page
Loading...