42
Operating the Replifex
™
Step 3
Step 4
Step 5
Step 6
Use the PARAMETER ADJUST control to select the controller number to be assigned to the
PA-A parameter. Any number from 0 to 120 may be selected, as well as OFF (will not
respond to MIDI control changes). Match the number selected for this parameter with the
controller number on the MIDI transmitter.
Turn the PARAMETER ADJUST control to scroll through the available parameters for the
current configuration.
Turn the PARAMETER SELECT control one step clockwise to display the parameter that is
currently mapped to the "CTR A" control number.
After selecting the desired controller number, press the STORE button to save the number for
the "CTR A" parameter. "STORED" will flash briefly on the display.
CTR A 7
STORED
PA-A BYPASS
PA-A REVERB LVL
Step 7
After selecting the parameter that you which to assign to a controller, press the STORE button
to save it. The Replifex
™
will flash "STORED" briefly.
STORED
To Next Page
Loading...
