60
Operating the Replifex
™
Step 5
Press the STORE button to begin restoring the selected preset into the selected location. After
the process is completed, the display should read "ERRORS 0". This represents the number
of bytes that the Replifex
™
found did not initialize properly. Any number of errors other than
"0" means that the Replifex
™
may not have initialized properly and the process should be
repeated.
!! CAUTION !!
Pressing the STORE button at this time will overwrite
the current preset with the displayed factory preset.
ERRORS 0
The Replifex
™
will remain in this condition until the FUNCTION SELECT control is
turned to exit the Factory Restore function. The preset currently recalled will be the preset
most recently restored into the current location.
To Next Page
Loading...
