18 Ethernet Network Appliance (with Network Address Translation)
Publication
9300-IN001A-EN-P - December 2012
Using the SD Card
The 9300-ENA ships without an SD card installed. Complete these steps to
install/remove the SD card from the 9300-ENA.
1. Verify that the SD card is not in use by checking to be sure the SD
indicator is off.
a. Verify that the SD card is locked or unlocked according to your
preference.
SD slot is for maintenance only and power must be disconnected or the area
known to be free of ignitable concentrations of flammable gases or vapors
when SD slot is used for maintenance.
When you insert or remove the Secure Digital (SD) memory card while power
is on, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
• Verify that the SD card status indicator is off and that the card is not in
use before removing it.
• We recommend that you do the following:
- Use the SD cards available from Rockwell Automation (catalog number
1784-SD1 or 1784-SD2).
• While other SD cards may be used with the controller, Rockwell
Automation has not tested the use of those cards with the controller. If
you use a SD card other than those available from Rockwell Automation,
you may experience data corruption or loss.
• Also, SD cards not provided by Rockwell Automation do not have the
same industrial, environmental, and certification ratings as those
available from Rockwell Automation.
Locked
Unlocked
To Next Page
Loading...
Need help?
General
