Rockwell Automation Allen-Bradley 1502 - Pre-energization Inspection; Storage

2-2 Receiving and Handling
1502-UM051E-EN-P – June 2013
Handling (cont.)  4FMFDUPSBEKVTUUIFSJHHJOHMFOHUITUPDPNQFOTBUFGPSBOVOFRVBMXFJHIU
distribution of the load and maintain the contactor in an upright position at
all times.
  5PSFEVDFUIFUFOTJPOPGUIFSJHHJOHBOEUIFDPNQSFTTJWFMPBEPOUIFMJĕJOH
EFWJDFEPOPUBMMPXUIFBOHMFCFUXFFOUIFMJĕJOHDBCMFTBOEWFSUJDBMUP
FYDFFEEFHSFFT
  /FWFSMJĕBDPOUBDUPSBCPWFBOBSFBXIFSFQFSTPOOFMBSFMPDBUFE
8IFOBGPSLMJĕJTVTFEUPIBOEMFUIFFRVJQNFOUUIFGPMMPXJOHDPOTJEFSBUJPOT
should be taken:
1. Keep the contactor in an upright position.
  $BSFGVMMZCBMBODFUIFDPOUBDUPSPOUIFGPSLT
  6TFBTBGFUZTUSBQXIFOIBOEMJOHUPTUFBEZUIFDPOUBDUPSBOEBWPJETIJĕJOH
or tipping.
  "WPJEFYDFTTJWFTQFFETBOETVEEFOTUBSUTTUPQTBOEUVSOTXIFOIBOEMJOHUIF
contactor.
  /FWFSMJĕBDPOUBDUPSBCPWFBOBSFBXIFSFQFSTPOOFMBSFMPDBUFE
Pre-energization Inspection Before placing the contactor in service, inspect it carefully for possible damage
sustained in transit or during maintenance:
 r $IFDLUIBUBMMJOUFSQIBTFCBSSJFSTBSFDPSSFDUMZJOTUBMMFE
 r $IFDLIPVTJOHGPSBOZDSBDLTPSCSFBLTEVFUPJNQBDU
 r 1VTIPOUIFBSNBUVSFQMBUFSPUBUJOHTIBĕUPFOTVSFNFDIBOJTNJTJOHPPE
XPSLJOHPSEFS
 r *OTQFDUUIFDPOUBDUPSGPSEJSUTUSBZMPPTFIBSEXBSFUPPMTPSNFUBMDIJQTBOE
if necessary, vacuum clean.
Storage If it is necessary to store the contactor before it is put into service, be certain to
store it in a clean, dry, dust and condensation free area. Do not store the contac-
tor outdoors.
 4UPSBHFUFNQFSBUVSFTIPVMECFNBJOUBJOFECFUXFFO$UP$'UP
'*GTUPSBHFUFNQFSBUVSFĔVDUVBUFTPSJGIVNJEJUZFYDFFETTQBDFIFBUFST
should be used to prevent condensation. Preferably, the contactor should be
stored in a heated building having adequate air conditioning.