Rockwell Automation Allen-Bradley 1502 - Vacuum Bottle Replacement and Set-up Procedure

Maintenance 4-3
1502-UM051E-EN-P – June 2013
Vacuum Bottle Replacement e following procedure shall be used to remove and replace the vacuum and
Set-Up Procedure
bottles. is procedure can be performed with the contactor remaining in
 UIFQPXFSDFMMPGUIFDPOUSPMMFS"ĕFSUIJTQSPDFEVSFIBTCFFODPNQMFUFEUIF
DPOUBDUPSXJMMCFTFUVQUPPQFSBUFQSPQFSMZBUNĕ3FGFSUPUIF
"MUJUVEF"EKVTUNFOUQSPDFEVSFGPSPUIFSBMUJUVEFTFUUJOHPOQBHF
  'PSUIFTBGFUZPGUIFNBJOUFOBODFQFSTPOOFMSFNPWFUIFDPO-
trol wiring from the contactor by disconnecting the control
wire plug before starting any disassembly of the contactor.
 #FGPSFSFNPWJOHUIFWBDVVNCPUUMFTNBSLUIFJOTUBMMFECPUUMFTDMFBSMZUP
avoid confusing them with the replacement vacuum bottles.
  3FNPWFUIFGSPOUSFUBJOJOHCSBDFBOEBMMGPVSJOUFSQIBTFCBSSJFSTBTTIPXOJO
'JHVSF
Interphase Barriers
Retaining Brace
Figure 4.1 – Removal of Interphase Barriers
A T T E N T I O N