48 Rockwell Automation Publication ENET-IN002H-EN-P - August 2017
Chapter 4 Set the Network IP Address
Follow these steps to set the IP address of the module with a BOOTP/DHCP
server.
1. Start the BOOTP/DHCP software.
2. From the Tools menu, choose Network Settings.
3. Type the Subnet Mask of the network.
The Gateway address, Primary and/or Secondary DNS address, and
Domain Name fields are optional.
4. Click OK.
The Request History panel appears with the hardware addresses of all
modules that issue BOOTP requests.
5. Select the appropriate module.
6. Click Add to Relation List.
To Next Page
Loading...
