Rockwell Automation Publication 5069-UM007A-EN-P - February 2019 11
Compact 5000 EtherNet/IP Adapter Features Chapter 1
Secure Digital Card
The 5069-AEN2TR EtherNet/IP adapter supports the use of a Secure Digital
(SD) card to store all configuration data that is stored in nonvolatile memory,
for example, the IP address or network communication rate for each port.
The adapter supports the use of a 1784-SD1 (1 GB) and 1784-SD2 (2 GB)
card. You can use third-party SD cards with the controller. You can use SD
cards with as much as 32 GB of memory. Keep in mind, Rockwell Automation
does not test the use of third-party SD cards with the controller.
If you use an SD card other than those cards that are available from
Rockwell Automation, unexpected results can occur. For example, you can
experience data corruption or data loss.
SD cards that are not provided by Rockwell Automation can have different
industrial, environmental, and certification ratings as those cards that are
available from Rockwell Automation. These cards can have difficulty with
survival in the same industrial environments as the industrially rated versions
available from Rockwell Automation.
An SD card slot is on the front of the adapter.
TIP If the device enters Protected Mode each time the device powers up, check
the application to determine if there are active I/O connections that are
opened via the device.
IMPORTANT The 5069-AENTR adapter does not support the use of an SD card.
Compact 5000™ I/O
MOD PowerSA Power
To Next Page
Loading...
Need help?
General
