Publication 2711P-UM001D-EN-P - September 2005
Configuration Mode 4-7
RSLinx Enterprise Communications
The RSLinx Enterprise Communications screen shows a treeview of
installed communication cards and network configurations. You can:
• edit or view the driver settings for the communication protocol
used by your .MER application.
• edit the device address of the controller on the network.
The procedure for editing these settings is the same regardless of the
communication protocol. The only differences are the properties for
each communication protocol and the device address of the logic
controller. The properties for each communication protocol are
defined immediately after this section.
Terminal Settings
Networks and Communications
RSLinx Enterprise Communications
Communication Driver
Ethernet Driver
Has no properties to edit.
AB_ETH-1
<No Devices>
Serial-DF1
<No Devices>
To Next Page
Loading...
Need help?
General
