Rockwell Automation Publication 520-UM001I-EN-E - July 2016 251
Appendix J
PowerFlex 525 PM Motor Configuration
This chapter contains instructions and diagrams on configuring the
PowerFlex 525 drive for use with a PM motor.
To use PM motor control, you need to install the PowerFlex 525 drive firmware
revision 5.001 or later. If you wish to perform PM motor tuning by using the
PowerFlex 525 Startup Wizard in Connected Components Workbench, you also
need to install version 1.05 or later Add-on profile (AOP) and update to the
latest drive database for Connected Components Workbench.
These files are available for download at the Rockwell Automation Product
Compatibility and Download Center. For instructions, see Download Files
on
page 252.
For information on... See page...
Download Files 252
Automatic Configuration Using Drive Startup Wizard 254
Manual Configuration Using Drive Keypad 261
Additional PM Motor Configuration 262
Optional Parameter Adjustments for Optimum Performance 266
ATTENTION: It is the responsibility of the startup engineer / end user to use
proper safety precautions with any equipment used during this startup.
In no event will Rockwell Automation, Inc. be responsible or liable for indirect or
consequential damages resulting from the use or application of this equipment.
The examples and diagrams in this document are included solely for illustrative
purposes. Because of the many variables and requirements associated with any
particular installation, Rockwell Automation cannot assume responsibility or
liability of actual use based on the examples and diagrams.
No patent liability is assumed by Rockwell Automation, Inc. with respect to the
information, circuits, equipment. Or software described in this document. Rockwell
Automation reserves the right to make changes to this document without prior
notice. When using examples in this document the user recognizes that Rockwell
Automation cannot be made liable for any damage or claims. Because there are
many application-specific variables, users MUST ensure that products are correctly
used and the appropriate architecture is deployed. Reproduction of the contents of
this document, in whole or in part, without written permission of Rockwell
Automation, Inc. is prohibited.
To Next Page
Loading...
Need help?
General
