52 Rockwell Automation Publication 520-UM001I-EN-E - July 2016
Chapter 1 Installation/Wiring
CE Conformity
Compliance with the Low Voltage Directive and Electromagnetic Compatibility
Directive has been demonstrated using harmonized European Norm (EN)
standards published in the Official Journal of the European Communities.
PowerFlex 520-series drives comply with the EN standards listed below when
installed according to the installation instructions in this manual.
CE Declarations of Conformity are available online at:
http://www.rockwellautomation.com/products/certification/
.
Low Voltage Directive (2006/95/EC and 2014/35/EU)
• EN 61800-5-1 Adjustable speed electrical power drive systems – Part 5-1:
Safety requirements – Electrical, thermal and energy.
EMC Directive (2004/108/EC and 2014/30/EU)
• EN 61800-3 – Adjustable speed electrical power drive systems - Part 3:
EMC requirements and specific test methods
Machinery Directive (2006/42/EC)
• EN ISO 13849-1 – Safety of machinery – Safety related parts of control
systems -Part 1: General principles for design
• EN 62061 – Safety of machinery – Functional safety of safety-related
electrical, electronic and programmable electronic control systems
• EN 60204-1 – Safety of machinery – Electrical equipment of machines -
Part 1: General requirements
• EN 61800-5-2 – Adjustable speed electrical power drive systems - Part 5-2:
Safety requirement – Functional
Refer to Appendix G
for installation consideration related to Machinery
Directive.
ATEX Directive (94/9/EC and 2014/34/EU)
• EN 50495 – Safety devices required for the safe functioning of equipment
with respect to explosion risks.
Pollution Degree Ratings According to EN 61800-5-1
Pollution
Degree
Description
1 No pollution or only dry, non-conductive pollution occurs. The pollution has no influence.
2 Normally, only non-conductive pollution occurs. Occasionally, however, a temporary
conductivity caused by condensation is to be expected, when the drive is out of operation.
To Next Page
Loading...
Need help?
General
