Chapter 5 FactoryTalk Batch View introduction
83
The System Configuration and Defaults dialog box opens to the Batch
List tab.
The System Configuration and Defaults dialog box opens to the tab
that corresponds to the view that is open, which in this case is the
Batch List view.
2. Take a moment to examine all the tabs to see the variety of changes you
can make to the views in the FactoryTalk Batch View window.
3. Select Cancel to close the System Configuration and Defaults dialog
box without saving any changes.
Use the following instructions to exit FactoryTalk Batch View.
To exit the FactoryTalk Batch View:
1. Select the Exit button.
2. Select Yes to confirm the exit.
In this section you:
• Opened the FactoryTalk Batch View.
• Examined the FactoryTalk Batch View window.
• Added a batch to the Batch List.
• Started a batch.
• Responded to a signature request.
• Navigated through the SFC and Procedural Hierarchy views.
Exit the FactoryTalk Batch
View
summary
To Next Page
Loading...
Need help?
General
