119 of 136
7. Minimize Logix Designer so that the HMI is visible. On the Startup screen of the HMI, there is a multistate
indicator which shows the connection status of the PowerFlex 525 drive.
It will take about a minute for the PowerFlex 525 drive to be configured.
8. Wait until the ADC process has completed. This will be indicated by the drive’s connection status switching
from “Configuring” to “Running”. Once this occurs, continue to the next step.
ADC will automatically reset (power cycle) the drive as part of the configuration process. This is done
because some parameters require a reset before they take effect. If a drive is being replaced with an out-of-
the-box drive, you will typically see one or more resets during the ADC process.
To Next Page
Loading...
Need help?
General
