17 of 136
Part 2: Utilizing EtherNet/IP™ and Connected Components Workbench™ Software
Connected Components Workbench programming and configuration software supports the Micro800™ controllers, as well as the
PowerFlex 4-class drives and PanelView™ Component graphic terminals for your small machine applications.
In this section you will perform the following:
Connect to the PowerFlex 525 drive through the embedded EtherNet/IP via Connected Components Workbench software
Explore the different parameter groupings as well as the AppView.
Create a CustomView
Explore the Startup Wizard
Connecting to the Drive
1. Go to the computer’s desktop and double click the shortcut for Connected Components Workbench
software.
You will see the following splash screen while the software loads, which may take a few moments.
To Next Page
Loading...
Need help?
General
